Balaji Industrial and Agricultural Castings  
Quality that find
line
line
line
line
line
line
 

Drilling Equipment

ROTARY DRILLING RIGS

Rotary Drilling Rigs are manufactured in house with Technical Collaboration with SALZGLITTER of GERMANY.  We are developing our process of manufacturing continuously and have demonstrated the same in executing various International orders in time under Stringent Quality norms.  These Drilling Rigs are capable of drilling to a depths of 1000 meters and the maximum diameter of the Bore hole is 24".  The drilling is done in steps and depending upon the formation of the Bore different types of Drill Bits are used for high performance of the equipment.  The Rigs are equipped with high powered MUD PUMPS, WATER INJECTION PUMPS, FOAM PUMPS to support the Drilling operations.  Rotary Drilling is preferred in Sandy soils, Mud soils, Clay soils and other strata where drilling with DTH is not easy.

DOWN THE HOLE (DTH) DRILLING RIGS

These Drilling Rigs are powered with Air Compressors and drilling is done with the help of Latest Hammers and BITS of various sizes to achieve required diameter of Borehole.  These Rigs are designed to a higher penetration rates even in Hard Rock.  The major advantages of these Rigs are speedy work and low operating and maintenance cost.

HYDRAULIC RIG

Drilling Capacity : 165 dia x 225 mtrs. by DTH method HYDRAULIC RIG
Top Head  
Driving System : Hydraulic Motor & GearBox
RPM : 0 - 80 RPM
Torque : 300 Kg. mt.
Feed System  
Driving System : Hydraulic Cylinder & Multiplier
Max. pull down force : 5250 Kg.
Max. pull up force : 7600 Kg.
Top head Travel : 7050 mm
Water Pump : GP - 18 Triplex cylinder
: Double acting piston pump.
Oil cooler : 300 LPM
Leveling Jack : 4 Nos - 610 mm stroke.


COMBINATION DRILLING RIGS ( ROTARY and DTH)

These Rigs are designed for combined applications where formation of the Borehole varies to Sandy to Rock and Hard soils.  Where only Rotary is not feasible hence DTH Drilling is also required.  This can be achieved with adding up an Air Compressor and Hammers and Bits to a Rotary Rig.  Lot of design work is involved in arriving at a Drilling Rig depending up on the area of drilling, type of drilling, diameter of drilling etc.

ACCESSORIES FOR DRILLING

All the accessories are manufactured in house and tested for performance.  The material selection to the finished product is done with highest quality standards.

 
 

 


Send mail
 
dthrotarydrilling.com 
Home | About us | Subscribe | Advertise in Magazine | Board | Technical Papers | Interview | E-Paper | Editor's Desk | Media Kit | Directory | Contact Us | Site Map
Terms & Conditions - Disclaimer Copyright © 2009 dthrotarydrilling.com All rights reserved.